- Member ID
- #1262
- Messages
- 233
- Reactions
- 318
- Likes
- 67
- City
- Omaha
- State
- NE
- Country
- United States
- Vehicle
- 2019 Redeye
Heres a couple pictures of my hard wired Uniden R1 set up on a Blendmount unit! Wire comes down the A pillar and connects into the backside of the 12 volt plug in on the passenger side. I like the R1, it is a very good long range detector and it is somewhat small for where I have it mounted.
I am going to mod the mount to get the unit up another 1/2 higher. Cut the metal tab off in the one pic. I put the mount in as close up as I could for now. When it came to running the wires, I had a local pro do it. I have had my experience with broken trim tabs in the past. Took him 2 hours and cost $100.00 even! Work is guaranteed! I am to heavy handed to start pulling panels off and it was for me money well spent.
![59138155906__4D57E32B-932A-4B66-B62F-B1044AA2EEDB.JPG](/data/attachments/3/3325-9b43b9440b5b005e690e205c7a414d94.jpg)
I am going to mod the mount to get the unit up another 1/2 higher. Cut the metal tab off in the one pic. I put the mount in as close up as I could for now. When it came to running the wires, I had a local pro do it. I have had my experience with broken trim tabs in the past. Took him 2 hours and cost $100.00 even! Work is guaranteed! I am to heavy handed to start pulling panels off and it was for me money well spent.
![59138152226__CA44987F-F731-42F6-BB0A-80E6CA4D00AF.JPG](/data/attachments/3/3324-5f3f9a7f489b7201e35494d17c23667b.jpg)
![59138155906__4D57E32B-932A-4B66-B62F-B1044AA2EEDB.JPG](/data/attachments/3/3325-9b43b9440b5b005e690e205c7a414d94.jpg)
Last edited: